Custom made PVC Grease Traps

 

 

 

Used mainly in restaurants and food service kitchens, grease traps are designed to trap fats, oils and grease before they enter the waste line. These contaminants are commonly found in sinks and various cooking or kitchen equipment such as dishwashers and wok burners. Similar trade waste tanks are used at various industry sectors including mechanical workshops and manufacturing plants. Without a grease trap, fats, oils & grease enter the pipes where they can solidify and cause costly blockages and backups and have a massive environmental impact.

 

Our grease traps, also known as grease trap interceptors, are fabricated from a minimum of 6mm cast PVC or Polypropylene sheet, and up to 12mm thick depending on the application. We have a standard size chart (below) that are most in demand although we often make custom sizes as small as 100 Liters for fitment under benches, sinks etc and oversize units for larger waste collection over 5000 Liters. Custom units can be built to incorporate pump wells and house other plumbing hardware if required.

All PVC traps are fully hand welded and the Polypropylene models use an extrusion process. The above ground models are supplied with stainless steel fittings, external steel supports for reinforcement and a completely sealed lid. One or two screw cap access covers are often used on the above ground models for easy access and to provide a perfect seal. The caps can also be optioned with locking capability for outdoor use. Vents, inlets and outlets are all standard PVC sizes for easy commissioning. They may be moved within the parameters of the applicable water authority for specific fitment.

The below ground models are usually supplied with Gattic lids or road covers for light, medium or heavy traffic areas. The external wall face of the below ground models also have provisions for concrete reinforcement rods to pass through the walls.

 

Quality control is second to none and all grease traps are spark tested (electronic leak detection) before the external welds are made. These designs have been proven to withstand many years of trouble free operation, and are a more cost effective solution when compared to stainless steel types and 'off the shelf' models available at the local hardware shop. All our grease trap interceptors are designed to DVS international standards, strictly adhere to EPA regulations and have been approved by many Australian water authorities.

 

If your not quite sure what you need, give us a call to discuss the best possible solution for your particular site.

 

Guaranteed best prices in Victoria.

 

 

Give us a call today to quote on your specific waste application on (03) 54 428 728.

 

Standard grease trap / interceptor size chart
Capacity in Liters	Length mm	Width mm	Height mm
100	610	410	620
150	700	470	680
200	800	500	710
250	900	530	740
300	900	600	880
400	1100	700	880
500	1200	600	1000
600	1200	750	990
700	1200	750	1100
800	1500	750	1020
900	1500	900	990
1000	1500	900	1050
1100	1500	900	1140
1500	1800	900	1230
2000	2400	900	1230
3000	3600	900	1230
Please contact us for larger or custom sizes

 

 

 

 

 

150 Liter above ground PVC Grease Trap Interceptor with sealed screw cap access, 100mm inlet, 100mm outlet and 50mm breather.		2000 Liter below ground PVC Grease Trap Interceptor, with wall reinforcement, provisions for concrete reinforcement, 100mm PVC inlet, outlet and vent.

 

 

 

 

 

1100L above ground grease trap with Galvanised steel support rails and 2 screw cap access holes.